Table of Contents
Advertisement
Installation and
Operation
The topics covered in this section are:
•
•
•
Rear Panel Features
* See first NOTE, below.
Figure 2.
WARNING:
NOTES:
Rear Panel Features
Front Panel Features
System Operation
100-240V
0.3A
1
2
OUT
IN
OUT N/A
A
50/60 Hz
1
3
2
3
FOX DA8 Plus Connectors
Risk of serious physical injury: This unit outputs continuous invisible
light, which may be harmful to the eyes; use with caution. For additional
safety, plug the attached dust caps into the optical transceivers when the
fiber optic cable is unplugged.
Input LC connectors (on the right) marked with an asterisk (*) in figure 2
•
(inputs 3, 5, and 7) are functional only when selected as an input using the
DA configuration switch
blocks 2, 4, 6, and 8 can never be functional.
•
Singlemode and multimode devices are not interchangeable. Ensure that
you connect transmitting and receiving devices that are compatible with the
FOX DA8 Plus.
•
Ensure that you use the proper fiber cable for your system. Typically,
singlemode fiber has a yellow jacket and multimode cable has an orange or
aqua jacket.
•
In this guide, the term "sending connector" refers to an LC connector on a
device that outputs a fiber optic signal. The term "receiving connector" refers
to an LC connector that receives an optical signal.
OPTICAL OUTPUTS
3
4
5
6
OUT
IN
OUT N/A
OUT
IN
OUT N/A
B
C
3
2*
3
3
2*
3
(item
d). The connector on the right for transceiver
FOX DA8 Plus • Installation and Operation
FOX DA8 Plus
7
8
OUT
IN
OUT N/A
RS-232
Tx Rx
D
3
2*
3
4
5
4
Advertisement
Table of Contents
