Table of Contents
Advertisement
Installation and
Operation
The topics covered in this section are:
z
z
z
Rear Panel Features
Figure 2.
WARNING:
NOTES:
a
Rear Panel Features
Front Panel Features
System Operation
100-240V
0.3A
1
2
OUT
IN
OUT N/A
INPUT
50/60 Hz
1
3
2
3
FOX DA8 Connectors
This unit outputs continuous invisible light, which may be harmful and
dangerous to the eyes; use with caution. For additional safety, plug the
attached dust caps into the optical transceivers when the fiber optic cable
is unplugged.
Singlemode and multimode devices are not interchangeable. Ensure that you
•
connect transmitting and receiving devices that are compatible with the
FOX DA8.
Ensure that you use the proper fiber cable for your system. Typically,
•
singlemode fiber has a yellow jacket and multimode cable has an orange
jacket.
In this guide, the term "sending connector" refers to an LC connector on a
•
device that outputs a fiber optic signal. The term "receiving connector" refers
to an LC connector that receives an optical signal.
AC power connector — Plug a standard IEC power cord into this connector to connect
the FOX DA8 to a 100 VAC to 240 VAC, 50 or 60 Hz power source.
OPTICAL OUTPUTS
3
4
5
6
OUT N/A
OUT N/A
OUT N/A
OUT N/A
3
3
3
3
Extron FOX DA8 • Installation and Operation
FOX DA8
7
8
OUT N/A
OUT N/A
RS-232
Tx Rx
3
3
4
4
Advertisement
Table of Contents
