Installation And Operation; Installation Overview; Mounting Options - Extron electronics DA2 RGBHV User Manual

Installation and Operation

Installation Overview

Install a DA RGB/YUV by performing the following steps:
Turn off the input and output devices, and unplug their
1
power cords.
If desired, mount the DA in a rack, under a furniture
2
surface, or through furniture. See Mounting Options,
below.
Connect the input and all desired outputs. See Rear Panel
3
Connections later in this chapter.
Plug in the DA and the input and output devices. Turn on
4
the input and output devices. See Operation and
Troubleshooting later in this chapter.

Mounting Options

Rack mounting the DA
Rack mount the DA as follows:
Rack mounting the DA2
1. If rubber feet were installed on the bottom of the DA,
remove them.
2. Place the DA on one half of an optional RSU 129 1U
(one unit high, 19" wide) rack shelf (part #60-190-01).
Align the front of the DA with the front of the shelf, and
align the threaded holes on the bottom of the DA with the
holes in the rack shelf (figure 2-1).
3. Secure the DA to the rack shelf with the two provided
4-40 x 3/16" machine screws. Insert the screws from the
underside of the shelf, and securely fasten them at
diagonally opposite corners.
4. Fasten the false front panel (provided with the rack shelf)
to the unoccupied side of the rack (figure 2-1), or install a
second half-rack-width device in that side by repeating
steps 1 through 3.
5. Secure the rack shelf to the rack using four 10-32 x 3/4"
bolts. Insert the bolts through #10 beveled washers, then
through the holes in the rack mounting flanges.
2-2 DA RGB/YUV Distribution Amplifiers • Installation and Operation
False front panel
uses 2 front holes.
D A
W ID
R G
EB
A N B /Y
D D
IS TR U V
S E
IB U
TI O R IE
N A
M PL S
IF IE
R
Figure 2-1 — Rack mounting a DA2 RGBHV
DA RGB/YUV Distribution Amplifiers • Installation and Operation
Use 2 mounting holes on
opposite corners.
(2) 4-40 x 3/16" Screws
2-3