Table of Contents
Advertisement
12
• Press repeatedly the MENU button to return the menu mode.
3.10 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Press the MENU button so many times until the display shows Stand Alone, then press ENTER.
• Select Master/Slave, then press the ENTER button.
• Using UP/DOWN, select the desired mode and then press the ENTER button.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Set the slaves to the same DMX modes.
NOTE: the unit, set in Static or Effect mode, always appears to be Master.
3.11 EFFECTS MODE
This fixture has a built-in automatic program. To access this, please see the below instructions:
• To enter the Effects mode, press the MENU button to access the menu.
• Throught the UP/DOWN button select Stand Alone, then select Effect. Press ENTER to confirm
• Use UP/DOWN to select the desired program Effect 1, ..., Effect 9, then press ENTER to confirm.
• Set the value (1 - 100), through UP/DOWN, then press ENTER to confirm.
NOTE: after selecting the described mode, the unit will be Master.
3.12 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the MENU button to access the main menu. Press the UP/DOWN button to select Stand Alone, then
press the ENTER button to access the next menu.
• Select Static, then press the ENTER button.
• Select Fixed Color through the UP/DOWN buttons, then press ENTER.
• Set the colors R , G , B, W, GB, RB, RG, RGB, RW, GW, BW, RGW, RBW, GBW, RGBW through the UP/DOWN buttons,
then press ENTER.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE: after selecting the described mode, the unit will be Master.
3.13 MANUAL MODE
This mode allows to combine the colors red, green, blue and white (R, G, B, W).
• Press the MENU button to access the main menu. Press the UP/DOWN button to select Stand Alone, then
press the ENTER button to access the next menu.
• Select Static, then press the ENTER button.
• Select Manual Color through the UP/DOWN buttons, then press ENTER.
• Select the color R, G, B, W through the UP/DOWN buttons, then press ENTER.
• Using UP/DOWN buttons, select the desired color value 000 - 255.
• Press ENTER button to continue to the next color R, G, B,W.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
NOTE: after selecting the described mode, the unit will be Master.
SOLAR48Q
Advertisement
Chapters
Table of Contents
