Fixing System; Fixing Assembly; Pre-Procedure For Removing Fixing Unit; Removing Fixing Unit - Canon LBP7200Cdn Service Manual

3.5 FIXING SYSTEM

3.5.1 Fixing Assembly

3.5.1.1 Pre-procedure for removing fixing unit

1) Remove the right cover.(page 3-3)Reference[Removing right cover]
2) Remove the upper rear cover (left).(page 3-1)Reference[Removing up-
per rear cover (left)]
3) Remove the upper cover.(page 3-5)Reference[Removing upper cover]
4) Remove the left cover.(page 3-4)Reference[Removing left cover]
5) Remove the rear cover.(page 3-1)Reference[Removing rear cover]
6) Remove the lower rear cover.(page 3-1)Reference[Removing rear cov-
er]
7) Remove the rear cover lib unit.(page 3-1)Reference[Removing rear cov-
er lib unit]
8) Remove duplex reverse drive unit.(page 3-9)Reference[Removing du-
plex reverse drive unit]

3.5.1.2 Removing fixing unit

1) Remove the cable guide [1] and then remove the connector [2].
2) Remove the cable [1] from the cable guide [2].
- 1 wire saddle [3]
- 3 connectors [4]
F-3-124
F-3-125
CAUTION:
When you assemble the fixing unit, be sure to place the cable in the correct
position as shown in the figure.
0021-4265
0021-4266
3) Remove the fixing unit [1].
- 2 screws [2]
Chapter 3
F-3-126
3-29