Drive Unit; Pre-Procedure For Removing Drive Unit; Removing Drive Unit - Canon LBP7200Cdn Service Manual

Chapter 3
7) Remove the front cover [1].

3.1.7 Drive Unit

3.1.7.1 Pre-procedure for removing drive unit

1) Remove the right cover.(page 3-3)Rfeference[Removing right cover]
2) Remove the upper rear cover (left).(page 3-1)Reference[Removing up-
per rear cover (left)]
3) Remove the upper cover.(page 3-5)Reference[Removing upper cover]
4) Remove the right frame cover.(page 3-3)Reference[Removing right
frame cover]
5) Remove the power supply unit.(page 3-13)Reference[Removing power
supply unit]
6) Remove the drum motor.(page 3-19)Reference[Removing drum motor]
7) Remove the developing motor.(page 3-19)Reference[Removing devel-
oping motor]
8) Remove the DC controller PCB.(page 3-10)Reference[Removing DC
controller PCB]
9) Remove the driver PCB.(page 3-12)Reference[Removing driver PCB]
10) Remove the relay PCB.(page 3-10)Reference[Removing relay PCB]
3-8
F-3-29
F-3-30
11) Remove fixing motor.(page 3-32)Reference[Removing fixing motor]

3.1.7.2 Removing drive unit

1) Remove the cable guide [1] in the arrow direction.
- 1 screw [2]
2) Remove 1 mounting screw [2] of the sheet metal[1].
3) Remove the sheet metal [1].
- 5 screws [2]
0021-4200
4) Remove the cable guide [1] and flat cable [2] at the same time.
- 1 claw [3]
F-3-31
F-3-32
F-3-33
0021-4201