Connecting To The Network - Sony DWR-R02D User Manual

Connecting to the Network

Receiver
Hub
RMU-01
By using the straight LAN cables, connect the receiver,
RMU-01, and the PC through the hub. When the network
connection is correctly made, the LED on the LAN
connector area at the rear of the receiver lights up green.
Connect the devices required for system operation to the
rear panel of the receiver.
For details on connecting devices, refer to the Operating
Instructnions supplied with the receiver.
Notes
• If the LED on the LAN connector area at the rear of the
receiver does not light up green, check the connection.
• For connections, use a category 5 or superior LAN cable
with a maximum length of 100 m (330 ft). If the
connection requires a total cable length exceeding 100 m
(330 ft), use a hub between the PC and the device.
• Use the cross cables when directly connecting the PC
and the devices.
• Do not touch the LAN connector directly with your
hands. The transfer of static electricity may result in
malfunction of the unit. As static electricity can
discharge from your body and clothes, be sure to remove
any static electricity before connecting or disconnecting
the LAN cable.
PC
Preparing the Software and Devices
7