Adding an IP address to the list for
exclusion from automatic detection
Click "Add," enter the IP address you wish to exclude
from detection, and then click "Close."
Changing an IP address on the list
Click the IP address you wish to change, click "Edit,"
make the desired changes, and then click "Close."
Removing an IP address from the list
Click the IP address you wish to delete, click "Delete," and
then click "Close."
Setting lock Window
You can prohibit the modification of receiver and
transmitter settings from Wireless Studio. An
administrator password must be configured to use this
function.
When setting modification is prohibited (i.e., locked), you
can temporarily enable setting changes by clicking the lock
release buttons in the Property window and the Property
List tab, and then entering the administrator password.
Locking settings
1
Select the "Setting lock" check box.
2
Enter the same password in the "Administrator
Password" and "Confirm Password" fields.
3
Click "OK."
Releasing the settings lock
1
Enter the configured password in the "Administrator
Password" field.
2
Clear the "Setting lock" check box.
3
Click "OK."
Changing the administrator password
1
Enter the configured password in the "Administrator
Password" field.
2
Enter the new password in the "Administrator
Password" and "Confirm Password" fields.
3
Click "OK."
Receiver CH Label setting Window
The "Receiver CH Label setting" window allows you to
configure a label for each receiver channel. This makes
channel identification easier in situations where a
transmitter's frequency cannot be received, for example.
Note
The "Receiver Name" and "Transmitter Name" settings
cannot be changed in this window. To change these
settings, use the Property List tab or Property window.
1
2
35
Setup Windows