Preparing The Software And Devices; Installing The Software - Sony DWR-R02D User Manual

Pairing-assist function
The software includes a pairing wizard to assist in pairing,
an operation that is necessary to enable remote control of
transmitters via wireless remote control.
Save and analyze functions for signal
environment timelines
The RF Chart Grapher function allows you to monitor and
save the signal environment and alert information on a
timeline, and the RF Chart Analyzer function allows you
to reference the files saved with the RF Chart Grapher.
Preparing the Software
and Devices

Installing the Software

Notes
• If the older version of Wireless Studio is already
installed in the PC, uninstall it (see page 6).
• Quit all applications before installing the software.
• Be sure to log in as the administrator.
Notes on installation
The installation procedure below describes the operation
on the PC that runs Windows XP. Note that the procedure
may vary according to the operating system.
1
Insert the CD-ROM "Wireless Studio" in your CD-
ROM drive.
2
Click "Start" and then click "Run".
3
Click "Browse" and then select the CD-ROM drive.
4
Select "setup.exe" and click "Open".
This opens the "Welcome to the InstallShield Wizard
for Wireless Studio".
5
Click "Next".
A message "Choose an area" appears.
If Wireless Studio is already installed, a message
"Program Already Installed" appears. When this
message appears, select "Repair" to overwrite the
installation, or select "Remove" to first uninstall the
software, and then perform step 4 again.
6
Select your region and click "Next".
7
Verify and if necessary, change the location where the
software is installed.
To change the location, click "Change..." and change
the location where the software is installed.
8
Click "Next".
9
Click "Install".
Installation starts.
When all application files have been copied to the PC,
a message "InstallShield Wizard Completed" appears.
10
Click "Finish".

Preparing the Software and Devices

5