Setting Up The Network - Sony DWR-R02D User Manual

To uninstall the software
Note
The uninstallation procedure below describes the
operation on the PC that runs Windows XP. Note that the
procedure may vary according to the operating system.
Click and select "Add or Remove Programs" in the
Windows Control Panel, then select "Wireless Studio"
from the list, and then delete it.

Setting Up the Network

This section describes the network settings for the
receiver, RMU-01, and PC.
IP addresses and subnet masks
• If you are not using a standard network line connection,
configure the following private address. Configure
values that are unique within the network for the "*"
value.
IP Address: 192.168.0.*
Subnet Mask: 255.255.255.0 (fixed length)
• If you are using a standard line connection, consult your
network administrator.
Receiver Network Settings
Make settings on the front panel of the receiver.
For details on making the settings, refer to the Operating
Instructions supplied with the receiver.
RMU-01 Network Settings
Make settings by using the Setting Tool software supplied
with the RMU-01.
For details on making the settings, refer to the User's
Guide supplied with the RMU-01 Setting Tool.
PC Network Settings
1
Select "Start > Control Panel > Network and Internet
Connections".
2
Click "Network Connections".
3
Right-click the local area connection icon and then
click "Properties".
4
Double-click "Internet Protocol 4 (TCP/IP)".
The properties window of the local area connection
opens up.
6
Preparing the Software and Devices
5
Double-click "Internet Protocol (TCP/IP)".
The internet protocol (TCP/IP) properties window
opens up.
6
Click "Use the following IP address", and then enter
the IP address in the IP address field.
Note
Make sure not to use an IP address that is already
assigned to another device on the network.
7
Enter the subnet mask into the Subnet mask field.
Note
If you configure a value other than "255 255 255 0",
the search for the receiver on the network will take a
long time.
8
Click "OK" to close the internet protocol (TCP/IP)
properties window.
9
Click "Close" to close the local area connection
properties window.