Sony DWR-R02D User Manual page 29

can select the following conditions as triggers for lighting
the ALERT indicator.
• RF low (RF level too low)
• RF over (RF level too high)
• QL low (QL too low)
• AF Peak (audio output level too high)
• Transmitter Battery low (remaining battery on
transmitter is low)
• Encryption unmatch (password or encryption key for the
encrypted communication function does not match)
• External word sync unlock (external word clock signal
not synchronized)
Channel tabs 1/2
Displays setting items that are equivalent to those in the
RECEIVER, TRANSMITTER, and RF REMOTE menus
of the receiver.
For details on the setting items in each menu, refer to the
Operating Instructions supplied with the receiver.
Receiver menu
GP/CH: Displays the frequency group and channel
configured for the receiver channel.
Frequency: Displays the frequency configured for the
receiver channel.
Setting button: Press this button to display the "Group/
Channel Setting" dialog box. You can select the reception
frequency from the channel plan configured for the
receiver in the "Group/Channel Setting" dialog box.
Active Channel Scan button: Press this button to execute
the receiver's active channel scan function. You can select
the channel for receiving from the detected channels.
Clear Channel Scan button: Press this button to execute
the receiver's clear channel scan function. You can select
the channel for receiving from the detected channels.
Encryption: Configure settings for the receiver's
encrypted communication function.
BAL Out Level: Configure settings for the receiver's
analog audio output level.
UNBAL Out ATT: Configure attenuator settings for the
UNBALANCED OUTPUT 1/2 connector.
Note
This function is not supported on the DWR-R01D.
Ground Lift: Configure whether to connect the
GROUND (XLR 1 pin) of the BALANCED OUTPUT 1/2
connector to a chassis GROUND. You can avoid hum,
buzz, and other noise caused by GROUND LOOP by
selecting "LIFT" to lift GROUND (XLR 1 pin) from the
chassis GROUND.
Note
This function is not supported on the DWR-R01D.
Transmitter menu
Transmitter Type: In online mode, this setting cannot be
changed. Specify the model of the transmitter paired with
the receiver in offline mode.
Transmitter Name: Sets the name for the transmitter.
Power save: Configure settings for the transmitter's
power-saving function.
29
Setup Windows