Sony DWR-R02D User Manual page 18

2
Select "File menu > Save as."
The current configurations are saved as a settings file.
Note
When saving transmitter settings, make sure that the
transmitters are active and that signals are received
properly. If the information is not received properly from
a transmitter, the factory default settings of that transmitter
will be saved.
Opening files and editing settings
1
Remove the check mark next to "Online monitoring
and control" in the Device menu.
The system enters offline mode.
2
Select "File menu > Open."
3
Select the previously saved file, and click "OK."
The information stored in the file is displayed on the
Wireless Studio screen.
4
Edit the setting values.
Settings values can be edited in the Property window
or the Property List tab of the sub window.
For details on changing the settings, see "Property
List Tab" on page 24 and "Property Window" on
page 28.
When you are finished editing, save the settings to a file if
necessary.
Note
You can change the "Receiver Model" and "Transmitter
Type" settings when editing settings in offline mode.
However, if you specify a setting that differs from the
actual setting of the device, an inconsistency will occur
when you apply the setting using the "Load settings"
function. The cells for these "Receiver Model" and
"Transmitter Type" settings will be displayed in yellow.
Make sure to use the actual model name and type of the
device when changing the "Receiver Model" and
"Transmitter Type" settings.
Opening files and applying settings
1
Remove the check mark next to "Online monitoring
and control" in the Device menu.
The system enters offline mode.
2
Select "File menu > Open."
3
Select the previously saved file, and click "OK."
18
Basic Operations
The information stored in the file is displayed on the
Wireless Studio screen.
Edit the settings here if necessary.
4
Select "Device menu > Load settings > All Receiver's
settings or All Receiver's and All Transmitter's
settings."
The settings are applied to the devices. The devices to
which the settings are applied will depend on the
option you selected.
If "All Receiver's settings" is selected
The settings are applied to all the receivers that appear
in the device list.
If "All Receiver's and All Transmitter's
settings" is selected
The settings are applied to all the receivers that appear
in the device list and their paired transmitters.
If for some reason the stored values could not be
applied to a setting item, the cell for that item will be
displayed in yellow in the Property List tab. In such
cases, make sure to check the status and setting values
of the devices.
Notes
• The following conditions must be met for the settings to
be applied to the receivers.
- The IP addresses of the receivers that appear in the
device list must be the actual IP addresses of the units.
- The "Receiver Model" settings must be the actual
models of the receivers.
• The following conditions must be met for the settings to
be applied to the transmitters.
- The transmitters are paired.
- The "Transmitter Type" settings must be the actual
types of the paired transmitters.
- The transmitters are within the wireless remote control
service area.