Table of Contents
Advertisement
D-Link
Primary DNS Server
Secondary DNS Server
Lease time(sec)
Routing Protocol
OSPF Area ID
Step 2 ¡ Ð
Setup LAN port
Here we are going to configure the LAN1 settings.
Setup IP Address and IP Subnet Mask, and
determine if you would like to enable the DHCP
Server. And then select Routing Protocol. Click
Apply to finish this setting.
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
IP Pool Starting Address
Pool Size
Primary DNS Server
Secondary DNS Server
Lease time(sec)
Routing Protocol
OSPF Area ID
Specify the Primary DNS Server IP address of the DHCP information.
Specify the Secondary DNS Server IP address of the DHCP information.
Specify DHCP information lease time
Determine to enable the dynamic routing protocol (RIP), to receive RIP
message, to send out RIP message if the message is received or not.
Specify OSPF area ID number
Table 3-2 Configure DMZ network settings
BASIC SETUP > LAN Settings > LAN1 Status
LAN port IP address
LAN port IP subnet mask
Enable LAN port of the DHCP Sever or not
Specify the starting address of the DHCP IP address.
Specify the numbers of the DHCP IP address.
Specify the Primary DNS Server IP address of the DHCP information.
Specify the Secondary DNS Server IP address of the DHCP information.
Specify DHCP information lease time
Determine to enable the dynamic routing protocol (RIP), to receive RIP
message, to send out RIP message if the message is received or not.
Specify OSPF area ID number
Table 3-3 Configure LAN network settings
DESCRIPTION
18
Part I
10.1.1.254
7200
None
EXAMPLE
192.168.40.254
255.255.255.0
Enabled
192.168.40.100
20
192.168.40.254
7200
None
Advertisement
Table of Contents
