Table of Contents
Advertisement
D-Link
Step 6 ¡ Ð
Customize the Rules
Enter a rule name such as inFTP, enter the
Source IP as 140.113.179.3 and the netmask
as 255.255.255.255. Enter the Dest. IP as
and
192.168.40.1
255.255.255.255. Select the action to be
inFTP. In this way, all FTP Server to PC1_1
packets will be put into the inFTP queue and
scheduled out at 1019kbps bandwidth. Click
Apply to store the changes. Repeat the same
procedure for the inVideo class.
FIELD
Activate this rule
Status
Rule name
Source IP & Netmask
Dest. IP & Netmask
Service
Condition
Configure src. port?
Configure dest. port?
Queue the matched
Action
packets in class
Back
Apply
Reset
ADVANCED SETTINGS > Bandwidth Mgt. > Edit Rules > Insert
the
as
netmask
Enable this bandwidth management rule
The bandwidth management rule name
When source IP address of incoming packets conforms the
"Source IP/Netmask" settings, do the "Action".
When destination IP address of incoming packets conforms
the "Dest IP/Netmask" settings, do the "Action".
Verify if the service of packet belongs to TCP, UDP, or
ICMP type.
If the service is TCP or UDP, we can setup the range of the
source ports. When selecting the range of source ports, it
can be a single port or a range of ports.
If the service is TCP¡ B UDP, we can setup the range of the
destination ports. When selecting the range of the
destination ports, it can be single port or a range of ports.
Allocate these packets which conform this rule to the
classes of the previous setting.
back to previous configuration page.
Apply the settings which have been configured.
Clean the filled data and restore the original one.
Table 17-5 Add a new Bandwidth Management rule
DESCRIPTION
110
Part VI
EXAMPLE
Enabled
InFTP
140.113.179.3
255.255.255.255
192.168.40.1
255.255.255.255
Any
disabled
disabled
inFTP
N/A
N/A
N/A
Advertisement
Table of Contents
