Table of Contents
Advertisement
D-Link
sys
status (st)
version (ver)
Note: If you don't know what parameter is followed by the commands, just type "?" following the command. Ex "ip ?". It will show
all the valid suffix parameters from "ip".
Privileged mode
Main
Sub
commands
commands
?
disable (dis)
exit (ex)
ip
arp
ifconfig
ping
tftp
traceroute
sys
halt
password
reboot
resetconf
status (st)
version (ver)
sys status
sys version
Table A-1 Non-privileged mode CLI commands
Example
?
disable
exit
ip arp status
ip ifconfig INTF1 192.168.1.100
255.255.255.0
ip ping 202.11.22.33
ip tftp upgrade all 1.2.3.4 preserve
ip traceroute 202.11.22.33
sys halt now
sys password
sys reboot now
sys resetconf now
sys status
sys version
Table A-2 Privileged mode CLI commands
Configure system parameters
Show system and network status
Show DFL-1500 firmware version
Show the help menu
Turn off privileged mode command
Exit command shell
Configure IP related settings
Show the ip/MAC mapping table
Configure the ip address of each port
Send ICMP messages
Upgrade/Backup from/to tftp server, refer to Section 20.2
for detailed description.
Trace route to destination address or hostname
Configure system parameters
Shutdown system
Change administrator password
Reboot system
Reset system configuration to default settings
Show system and network status
Show DFL-1500 firmware version
124
Command description
Part VII
Advertisement
Table of Contents
