Bag C - Team Losi XXX-NT Sport Owner's Manual

Figure 26
Step 1. Insert a 4-40 mini locknut (7) into the hex area of the diff nut
carrier (57). The thread-locking portion of the nut (7) should be to the
outside.
Figure 27
Step 2. Locate the 5/64" Allen wrench (59) supplied with the kit. Place
the diff nut carrier (57), nut side first, over the Allen wrench (59).
Step 3. Slide the #4 washer (23) over the wrench up against the diff
nut carrier (57).
Step 4. Slide the differential coil spring (58) over the wrench so that it
is up against the #4 washer as shown in Figure 27.
Figure 28
Step 5. Insert all of the parts that are stacked on the wrench into the
male outdrive/diff half (60). Line up the tabs on the diff nut carrier (57)
with the slots in the outdrive (60). Press the parts all the way into the
outdrive/diff half (60).
Figure 29
Step 6. Apply a small amount of diff grease (clear) (62) all the way
around the face of the outside ridge of the outdrive/diff half (60).
Attach a diff washer (61) to the outdrive (60) by centering the hole in
the washer (61) over the raised center of the outdrive (60).
*NOTE: Only a small amount of grease is needed, but be sure to
cover the entire face of the ridge on the outdrive.
IMPORTANT NOTE: Do not glue the diff washers to the
outdrive/diff halves. Doing so may not allow the washers to mount
flat.

BAG C

7
23
61
7
Figure 27
61
60
1 2
57
Figure 26
58
23
57
59
60
Figure 28
APPLY
GREASE
HERE
Figure 29