Team Losi XXX-NT Sport Owner's Manual page 12

Figure 19
7
Step 13. Insert a 3/8" ball stud (38) into the middle hole on top of each
spindle carrier (42), (43) from the front as shown, and tighten.
IMPORTANT NOTE: Do not overtighten the ball studs!
Step 14 . Insert a 4-40 mini locknut (7) into the hex area in the top of
each spindle (40), (41). Thread a 1/4" ball stud (10) into the nut from
the bottom of the spindle (40), (41) and tighten.
Figure 20
46 50
Step 15. Attach the right spindle and carrier assembly to a front sus-
pension arm (48) as shown in Figure 20. Note that the spindle arm
faces the side of the suspension arm (48) with the shock mount holes
(rear) and the ball stud pointing forward. Line up the holes in the
spindle carrier (42) with the holes in the front arm (48), insert a 1/8" x
.960" hinge pin
1/8" E-clip (46) to both sides of the hinge pin (50).
Step 16. Attach the arm (48) to the right side of the front pivot block
(49) by inserting a 1/8" x 1.42" hinge pin (51), from the front, through
the arm (48) and pivot block (49) as shown in Figure 20.
Step 17. Insert a 1/8" E-clip (46) in the groove in the rear of the hinge
pin (51) only.
Step 18. Repeat Steps 15-17 for the left spindle and carrier assembly
and remaining front suspension arm (48).
Step 19. Slide the front hinge pin brace (52) over the front of both
inner hinge pins (51). The E-clip grooves in both hinge pins (51)
should be exposed in front of the brace (52). Secure the brace (52) by
attaching a 1/8" E-clip (46) to the front of each hinge pin (51).
BAG B (Continued)
10
38
51
(50) and attach
7
10
48
42
a
50
9
38
42
Figure 19
49
51
46
Figure 20
52
46