Team Losi XXX-NT Sport Owner's Manual page 14

Figure 24
54
Step 25. Thread a long plastic rod end (54) onto each end of a 2-1/4"
turnbuckle (55). Tighten both rod ends (54) equally until the rod is the
same length as the rod in Figure 24A. Make two of these tie-rod
assemblies.
Figure 25
Step 26. Snap one end of a completed tie rod assembly to the ball stud
(11) in the steering idler arm (8). Snap the other end to the ball stud
(10) in the right spindle (40). Attach the other tie rod assembly to the
ball stud in the bottom of the servo saver assembly (8) and the left
spindle (41).
Tip: Once again, assure that all turnbuckles are mounted with the
threads in the same direction for easier adjustment later.
BAG B (Continued)
55
54
8
11
1 1
55
Figure 24
Figure 24A
10
Figure 25
40