Team Losi XXX-NT Sport Owner's Manual page 19

Figure 38
80
Step 30. Insert two 3/16" x 3/8" sealed bearing (80) into the two top
bearing seats of the right gearbox half (82).
*NOTE: If any of the supplied gearbox bearings only have one
Teflon™ seal(colored, woven looking) in it, position the seal to the
outside of the gearbox half.
Step 31. Insert a 1/2" x 3/4" bearing (81) into the lower
bearing seat of the right gearbox half (82).
Figure 39
80
Step 32. Use the short, 4-40 thread-cutting screw included in the
wrench bag to pre-tap the three holes noted in Figure 39. Thread the
screw all the way into and out of each hole.
Step 33. Insert two 3/16" x 3/8" sealed bearing (80) into the two top
bearing seats of the left gearbox half (83).
Step 34. Insert a 1/2" x 3/4" bearing (81) into the lower
bearing seat of the left gearbox half (83).
Figure 40
Step 35. Slip the 3/16" x .015 shim (84) over the slipper shaft (73) up
against the top gear (75).
Step 36. Insert the slipper shaft (73) into the forward-most bearing
(80) in the left gearbox half (83).
Step 37. Insert the differential assembly into the 1/2" x 3/4" bearing
(81) in the right gearbox half (82). Insert the differential diff nut carrier
(57) side first.
*NOTE: be sure the head of the diff adjusting screw faces the
right side of the gearbox. This will allow easy adjustment while
running your truck.
BAG C (Continued)
81
81
84
80
81
83
81
83
81
64
1 6
Figure 38
PRE-TAP
THESE HOLES
80
Figure 39
80
84
Figure 40
82
75
73