Team Losi XXX-NT Sport Owner's Manual page 47

RADIO INSTALLATION
If your engine comes equipped with a rotary valve carburetor, complete the steps in Figure 98 through Figure 104. If
your engine comes equipped with a slide valve carburetor, skip ahead to page 47 and complete the steps in Figure 105
through Figure 111.
Figure 98
Step 24. Slide a linkage collar (192) over the end of the throttle Z-bend
wire(191) (the shorter of the two), and position it approximately 1/4"
(6mm) from the Z-bend. Secure the collar (192) with a 4-40 x 1/8" set
screw (193).
Step 25. Place the throttle over-ride spring (194) (longer of the two
springs) over the wire (191) and against the collar (192). Slide a plastic
over-ride slider (195) onto the wire (191), so that the long end is
towards the Z-bend.
Step 26. Place a brake over-ride spring (196) (black, shorter of the two
springs) over the wire (191) and against the over-ride slider (195).
Place a linkage collar (192) over the end of the wire (191), so that the
springs are somewhat compressed, and secure it with a 4-40 x 1/8"
setscrew (193). The collar (192) should be positioned at the end of the
wire (191). Final adjustments will be made later.
Figure 99
Step 27. Slide a linkage collar (192) over the end of the long, brake Z-
bend wire (197), and position it aproximately 2 1/4" (60mm) from the Z-
bend. Secure the collar (192) in place with a 4-40 x 1/8" set screw
(193).
Step 28. Slide a plastic over-ride slider (195) onto the wire (191), so
that the long end is towards the Z-bend. Place a brake override spring
(196) (black, shorter of the two springs) over the wire (191) and against
the slider (195).
Step 29. Slide a linkage collar (192) over the end of the wire (191) until
it just touches the spring (196). Secure it with a 4-40 x 1/8" setscrew
(193). Once again, final adjustments will be made later.
Rotary Valve Carburetors
193
193
193
191
194
193
192
195
4 4
(Continued)
192
195
196
Figure 98
196
193
192
Figure 99
193
192
197