Team Losi XXX-NT Sport Owner's Manual page 50

RADIO INSTALLATION
Figure 105
Step 24. Thread the 4mm ball cup (204) all the way onto the end of the
threaded throttle rod (203). Slide a linkage collar (192) over the other
end of the throttle rod (203), and up against the ball cup (204). Secure
the collar (192) with a 4-40 x 1/8" set screw (193).
Step 25. Place the throttle over-ride spring (194) (longer of the two
springs) over the rod (203) and against the collar (192). Slide a plastic
over-ride slider (195) onto the rod (203), so that the long end is away
from the ball cup (204).
Step 26. Place a brake over-ride spring (196) (black, shorter of the two
springs) over the rod (203) and against the over-ride slider (195).
Place a linkage collar (192) over the end of the rod (203), so the springs
are somewhat compressed, and secure it with a 4-40 x 1/8" setscrew
(193). The collar (192) should be positioned at the end of the rod
(203). Final adjustments will be made later.
Figure 106
Step 27. Slide a linkage collar (192) over the end of the long, brake Z-
bend wire (197), and position it approximately 3" (75mm) from the Z-
bend. Secure the collar (192) in place with a 4-40 x 1/8" set screw
(193).
Step 28. Slide a plastic over-ride slider (195) onto the wire (197), so
that the long end is towards the Z-bend. Place a brake over-ride spring
(196) (black, shorter of the two springs) over the wire (197) and against
the slider (195).
Step 29. Slide a linkage collar (192) over the end of the wire (197) until
it just touches the spring (196). Secure it with a 4-40 x 1/8" setscrew
(193). Once again, final adjustments will be made later.
Slide Valve Carburetors
If your engine comes equipped with a slide valve carburetor, complete the steps in
Figure 105 through Figure 111.
193
193
193
204
203
193
196
192
195
4 7
(Continued)
192
195
194
196
192
Figure 105
193
197
192
Figure 106
193