Team Losi XXX-NT Sport Owner's Manual page 46

RADIO INSTALLATION
Figure 96
Step 17. Remove the two small screws from the switch (supplied with
radio system). Place the switch, from the bottom, into the switch
mount (189).
Step 18. Place the switch top plate (if applicable) over the switch, on
top of the switch mount (189). Line up the holes in the switch with the
holes in the top plate and secure the switch to the switch mount (189)
with the two screws from the switch.
Step 19. Plug the switch lead into the slot marked "Battery" in the
receiver.
Tip: Some racers prefer to eliminate the switch and replace it with
a servo extension wire. If you wish to replace the switch with an
extension wire, plug one end of the wire into the slot marked "Bat-
tery" in the receiver.
Step 20. Plug the battery lead into the free end of the switch and make
sure that the switch is in the "off" position. Use a couple of small tie-
straps to secure the battery lead to the gearbox brace. This will keep
the wires away from any moving parts such as the gears, throttle and
brake linkages, etc.
Figure 97
Step 21. Slide the receiver cover (198) into place over the rails on the
top chassis brace (29), so that the top lip of the chassis brace (29) fits
up inside the receiver cover (198), and the notches at the bottom of
the receiver cover (198) fit into the holes in the chassis (19). Be carefull
to arrange the radio wires so that they fit through the mouse-holes in
the bottom of the receiver cover (198) and are not pinched under the
cover (198).
Step 22. Slightly bend the throttle return spring eyelet (199). Place the
throttle return spring eyelet (199) over one of the 4-40 x 3/8" cap-head
screws (17), and thread the screw (17) through the forward hole in the
receiver cover (198) and into the top chassis brace (29).
Step 23. Thread the other 4-40 x 3/8" cap-head screws (17) through
the rear hole in the receiver cover (198) and into the top chassis brace
(29).
17
189
198
19
4 3
(Continued)
Figure 96
Figure 97
17
199
29