Removing The Interface Cable; Connecting Power (If Required); Configuring The Digital Scanner - Motorola DS4208 Product Reference Manual

1 - 4 DS4208 Digital Scanner Product Reference Guide

Removing the Interface Cable

Press the cable's modular connector clip through the access slot in the digital scanner's base.
1.
Figure 1-3
Removing the Cable
Carefully slide out the cable.
2.
Follow the steps for
3.

Connecting Power (if required)

If the host does not provide power to the digital scanner, connect an external power supply.
Plug the power supply into the power jack on the interface cable.
1.
Plug the other end of the power supply into an AC outlet.
2.

Configuring the Digital Scanner

To configure the digital scanner use the bar codes included in this manual, or use the 123Scan
program. See Chapter 4, User Preferences & Miscellaneous Digital Scanner
for information about programming the digital scanner using bar code menus. See
information on using this configuration program. Also see each host-specific chapter to set up connection to a
specific host type.
Installing the Interface Cable to connect a new cable.
Options, and
2
configuration
Chapter 9, Symbologies
Chapter 10, 123Scan2 for