Setting Up the Digital Scanner
Installing the Interface Cable
Plug the interface cable modular connector into the cable interface port on the bottom of the scanner handle.
1.
(See
Figure
1-2.)
Gently tug the cable to ensure the connector is properly secured.
2.
Connect the other end of the interface cable to the host (see the specific host chapter for information on host
3.
connections).
Clip
Installing the Cable
Figure 1-2
NOTE Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Connectors vary from those illustrated, but the steps to connect the digital scanner remain
the same.
Removing the Interface Cable
Using the tip of a screwdriver, depress the cable's modular connector clip.
1.
Removing the Cable
Figure 1-3
Carefully slide out the cable.
2.
Follow the steps for
3.
Cable interface port
Interface cable modular
connector
To host
Installing the Interface Cable
to connect a new cable.
Getting Started
1 - 3