Table 17 - Monitor Mode Commands; Table 18 -Command Response Codes - Lantronix Device Server UDS 10 User Manual

Monitor Mode

Table 17 - Monitor Mode Commands

Command Command Name
DL Download
SF x.x.x.x Send Firmware
VS x.x.x.x Version
GC x.x.x.x Get Configuration
SC x.x.x.x Send Configuration
PI x.x.x.x Ping
AT ARP Table
TT TCP Connection
Table
NC Network Connection
RS Reset
SI Send/Set IP
xxx.xxx.xxx.xxx: Address
yyy.yyy.yyy.yyy
QU Quit
G0, G1, ....,Ge, Get configuration
Gf from memory page
S0, S1,...,Se, Sf Set configuration to
memory page
Responses to some of the commands are given in Intel Hex format (see The Intel Hex Format
on page 8-5).
Note: Entering any of the commands listed above will generate one of the following command
response codes:

Table 18 -Command Response Codes

Response Meaning
0> OK; no error
1> No answer from remote device
2> Cannot reach remote device or no
answer
8> Wrong parameter(s)
9> Invalid command
7-2
Function
Download firmware to the Device Server via the
serial port in hex format
Send firmware to Device Server with IP address
x.x.x.x
Query software header record (16 bytes) of
Device Server with IP address x.x.x.x
Get configuration of Device Server with IP
address x.x.x.x as hex records (120 bytes)
Set configuration of Device Server with IP address
x.x.x.x from hex records
Ping Device Server with IP address x.x.x.x to
check device status
Show the Device Server's ARP table entries
Shows all incoming and outgoing TCP
connections
Shows the Device Server's IP configuration
Resets the Device Server's power
Remotely assign an IP address to a Device
Server, where xxx.xxx.xxx.xxx is the IP address,
and yyyy.yyy.yyyy.yyy is the two-part identification
number at the bottom of the label, converted to
decimal, and written twice.
Exit diagnostics mode
Gets a memory page of configuration information
from the device.
Sets a memory page of configuration information
on the device.
UDS-10 User Guide