Setup; Setup Maintenance - Dukane iQ Series User Manual

User's Manual User's Manual

SETUP

Introduction
The screens available in Setup Maintenance allow the
operator to Load, Store, or Delete generator weld setups.
As many as eight (8) setups can be loaded and stored for
your convenience.
Navigating
1. When the SETUP key is pressed for the first time, the
display looks like Figure 5-13. This screen indicates
that Setup #1 is EMPTY. No data was available to use
for this setup, so it is empty.
Press ENTER.
Load
2. - A pop-up screen asks if defaults should be
loaded for Setup #1.
Select NO, and the previous setup mode screen
appears.
Select YES, and Manual mode is chosen as the current
mode, and the Operate screen is displayed..
3. After selecting YES, press SETUP, and the display
will look like Figure 5-14.
Store
4. - Tap the right arrow key once to highlight
Store. See Figure 5-15.
5. Press ENTER, and a pop-up screen appears.
See Figure 5-16.
6. Select YES if you want to overwrite (replace)
whatever is in the setup, and select NO if you do not
want to replace anything for that setup.
Press the ENTER key to save your selection.
Delete
7. - If you want to delete the setup, select Delete
as shown in Figure 5-17, and press the ENTER key. A
pop-up screen will appear to ask you to confirm your
choice.
Select YES or NO, and press ENTER again.
Page  Page 

Setup Maintenance

Store Delete
Load

Setup #

1
Empty
Figure 5-13 Setup Maintenance - 1
Setup Maintenance
Delete
Store
Load
Mode: Manual
Setup # 1
T: 0.000 S A: 100%
E: 0 J H: 0.0 S
Figure 5-14 Setup Maintenance - 2
Setup Maintenance
Store Delete
Load
Mode: Manual
Setup # 1
T: 0.000 S A: 100%
E: 0 J H: 0.0 S
Figure 5-15 Setup Maintenance - 3
Overwrite
Setup #1?
YES
NO
Figure 5-16 Overwrite Setup?
Setup Maintenance
Store Delete
Load
Mode: Manual
Setup # 1
T: 0.000 S A: 100%
E: 0 J H: 0.0 S
Figure 5-17 Setup Maintenance - 4
Dukane Manual Part No. 403-577-00