Dukane iQ Series User Manual page 19

Power Cords
200/240 Volt Systems
The IEC AC power inlet connector mounted on the rear
panel requires a properly configured IEC compliant power
cord.
The 200/240 AC power cords supplied with the
generators are matched to the ultrasonic output power
rating and the continent of specified use. See Table 3-I.
Continent of Use
North America
Europe
Table 3-I Standard IEC AC Power Cord Part Numbers
100/120 Volt Systems
The power cord (including strain relief) supplied with the
100/120 AC systems is permanently attached to the rear
of the generator. Units with this power cord are for use in
North America or Japan.
HAND PROBE Connector
Ultrasound Output
The ultrasound output connector used with this generator
is integrated into a D-Sub style connector. This connector
provides superior shielding of electrical noise. The output
connector mates with a fully shielded ultrasound cable
that is secured to the generator with two simple, reliable
thumbscrews.
The ultrasonic output from this connector (that drives the
attached ultrasonic load) is a very high AC voltage. At
high power levels there is high current, and the cable must
be securely attached to the hand probe for safe operation.
Only use original equipment ultrasound cables for safe
and reliable system operation.
Dukane Manual Part No. 403-577-00
Power Cord Power
Part Number
200 - 1541 240V, 10A
200 - 1542 240 V, 10A
(North America or Japan)
Section 3 – Installation
Page 3