Info; Hardware Settings Screen; System Information - Dukane iQ Series User Manual

INFO

When the INFO key is pressed the display looks like
Figure 5-11:
+ -
Using the keys, move the pointer to indicate:
System Information or Hardware Settings.
Press ENTER to make the selection.

System Information

1.
Manufacturer's information is shown including the
manufacturer's name, the name of the system (iQ Hand
Probe) and the software identification.
Figure 5-11A shows an example of this information.
Hardware Settings
2.
Figure 5-12 gives a view of the Hardware Settings
screen.
Audible Alarms - With the pointer as shown in Figure
5-12, the operator can turn the audible alarms on or
off. Use the
The current selection is highlighted.
Latching Faults - Latching faults can be turned on
or off.
If Latching Faults is on, and a fault occurs, the alarm
sounds twice (beep, beep) indicating the generator
is latched and it will not weld again until the fault is
corrected.
Pressing ENTER clears the fault, and the next cycle
can begin.
If Latching Faults is off, and a fault occurs, the audible
alarm (beep, beep) will be heard, but welding can
continue.
Dukane Manual Part No. 403-577-00
keys to move from ON to OFF.
iQ Information
> System Information
Hardware Settings
Figure 5-11 INFO Screen
Dukane Corporation
iQ Hand Probe
FP v1.25 MB v2.76
FPGA v8
Figure 5-11A System Information Example Screen
Hardware Settings
>
Audible Alarm
ON OFF
Latching Faults
ON OFF
Hit Enter To Accept
Hit Cancel To Abort
Figure 5-12 Hardware Settings Screen
NOTE
Changes in Hardware Settings take
place after ENTER is pressed.
NOTE
The Audible Alarm can be set ON or
OFF. See INFO, Page 27.
Section 5 - Menu Structure Section 5 - Menu Structure
Page 7 Page 7