Lexmark X203N Service Manual page 45

User status and attendance messages (Continued)
User primary message
37 Insufficient Collation
Area
38 Memory Full
39 Complex Page
54 Standard Network
Software Error
54 Network <x> Software
Error
This message is displayed when the printer memory used to store pages is too full
to collate the print job.
The following actions can be taken:
• press Select ( ) to print the portion of the job already stored, and begin
collating the rest of the job.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions are available.
- Cancel Job
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
This message is displayed when the printer is processing an incoming job and
there is not enough memory available to continue processing the job.
The following actions can be taken:
• Determine how to make more memory available to your print job by:
- Deleting fonts, macros and other data in RAM.
- Simplify your print job.
- Install additional memory
• press Select ( ) to clear the message and continue printing.
The job may not print correctly.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
This message is displayed when a page is too complex to print.
The following actions can be taken:
• press Select (
) to clear the message and continue printing.
The job may not print correctly.
• Simplify the print job.
• press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Cancel Job
- Reset Printer
Note: Menu Lockout does NOT prevent access to the Busy/Waiting Menu.
This message is displayed when the RIP software detects that a network port is
installed but cannot establish communications with it.
• press Select ( ) to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Turn the printer power off and then back on to reset the printer.
The printer disables all communications to the associated network interface. No
data may be received or sent from or to the associated interface. The user can
program new firmware in the network using the parallel port after this message
clears.
• press Select ( ) to clear the message and continue printing.
The job may not print correctly.
• Program new firmware for the network interface.
• Turn the printer power off and then back on to reset the printer.
Explanation
Diagnostic information
7011-2xx
2-21