5.
Lift the modem card up and away from the MFP.
Feed rollers (autocompensator tires) removal
1.
Remove the paper tray.
2.
Remove the toner cartridge.
3.
Tilt the MFP onto its back.
4.
Remove old tires from the hubs.
Note: When installing the new tires, ensure the new tires are captured between the rims of the plastic hub.
Fuser removal
1.
Remove the paper exit guide assembly. See
more information.
2.
Remove the two screws (A) securing the fuser.
3.
Disconnect the thermistor cable at J10 and exit sensor at J8 on the controller card.
"Paper exit guide assembly removal" on page 4-35
7011-2xx
for
4-21
Repair information