Serial Number; Engine Setting 1-4; Service Manual; Model Name - Lexmark X203N Service Manual

7011-2xx
To view the Prt Color Pg Count, the Prt Mono Pg Count, or the Perm Page Count:
1.
Select PRINTER SETUP from DIAGNOSTICS, and press Select (
2.
Select PAGE COUNTS, and press Select (
3.
Select the page count you wish to view:
•
Prt Color Pg Count
•
Prt Mono Pg Count
•
Perm Page Count
4.
Press Select (
The value of the page count appears.
Press Back (

Serial Number

The serial number can only be viewed. It cannot be changed.
To view or change the serial number:
1.
Select PRINTER SETUP from DIAGNOSTICS, and press Select (
2.
Select Serial number, and press Select (
Press Back (

Engine Setting 1-4

Warning: Do not change these setting's unless requested to do so by your next level of support.

Model Name

The model name can only be viewed and cannot be changed.

Configuration ID

The two configuration IDs are used to communicate information about certain areas of the printer that cannot be
determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is
manufactured. However, the servicer may need to reset Configuration ID 1 or Configuration ID 2 whenever the
system board is replaced. The IDs consist of eight digits. The first seven digits in each ID are hexadecimal
numbers, while the last digit is a checksum of the preceding seven digits. Each ID can contain a combination of
the digits 0 through 9, and the letters A through F.
Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs:
•
The default standard model Configuration ID is used instead.
•
Configuration ID is the only function available in DIAGNOSTICS.
• Unless the menu is in DIAGNOSTICS, Check Config ID displays.
To set the configuration ID:
1.
Select PRINTER SETUP from DIAGNOSTICS, and press Select (
2.
Select Configuration ID, and press Select (
The current value for Configuration ID 1 appears with the left character or digit underlined.
3.
Enter the Configuration ID 1.
•
Change the left character or digit first.
•
To change a character or digit, press
press Select (
3-8

Service Manual

).
)
to return to PRINTER SETUP.
)
to return to PRINTER SETUP.
).
).
).
).
).
).
).
to decrease or to increase the underlined value, and