Checking And Replacing The Rear Wheel Sprocket; Assembling The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha 2011 FZ8NA(C) Service Manual

EAS14B1003
CHECKING AND REPLACING THE REAR
WHEEL SPROCKET
1. Check:
• Rear wheel sprocket
More than 1/4 tooth "a" wear → Replace
the drive chain sprockets as a set.
Bent teeth → Replace the drive chain
sprockets as a set.
b. Correct
1. Drive chain roller
2. Rear wheel sprocket
2. Replace:
• Rear wheel sprocket
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the rear wheel sprocket nuts and
the rear wheel sprocket.
b. Clean the rear wheel drive hub with a clean
cloth, especially the surfaces that contact
the sprocket.
c. Install the new rear wheel sprocket.
Rear wheel sprocket nut
80 Nm (8.0 m·kgf, 58 ft·lbf)
TIP
Tighten the rear wheel sprocket nuts in stages
and in a crisscross pattern.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS22140

ASSEMBLING THE REAR WHEEL

1. Install:
• Wheel bearings
• Oil seal
New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-8.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the
rear wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT
WHEEL STATIC BALANCE" on page 4-8.
EAS22160
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
Rear brake disc bolt
20 Nm (2.0 m·kgf, 14 ft·lbf)
LOCTITE®
ECA1CW1401
Replace the brake disc bolts with new
ones.
TIP
Tighten the brake disc bolts in stages and in a
crisscross pattern.
4-15
REAR WHEEL
New