▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
5. Install:
• Upper bracket
Refer to "HANDLEBAR" on page 4-44.
EAS39P1303
LUBRICATING THE BRAKE LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
Recommended lubricant
Silicone grease
EAS39P1304
LUBRICATING THE CLUTCH LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the lever.
Recommended lubricant
Lithium-soap-based grease
EAS21710
LUBRICATING THE PEDAL
Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
Recommended lubricant
Lithium-soap-based grease
EAS21380
ADJUSTING THE SHIFT PEDAL
TIP
The shift pedal position is determined by the
installed shift rod length.
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
304.1–306.1 mm (11.97–12.05
in)
PERIODIC MAINTENANCE
2. Adjust:
• Installed shift rod length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
c. Tighten both locknuts.
d. Make sure the installed shift rod length is
within specification.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS21720
LUBRICATING THE SIDESTAND
Lubricate the pivoting point and metal-to-metal
moving parts of the sidestand.
Recommended lubricant
Lithium-soap-based grease
EAS39P1310
CHECKING THE SIDESTAND SWITCH
Refer to "ELECTRICAL COMPONENTS" on
page 8-93.
3-21