Installing The Swingarm - Yamaha 2011 FZ8NA(C) Service Manual

4. Check:
• Dust covers "1"
• Spacer "2"
• Oil seals "3"
Damage/wear → Replace.
• Collar "4"
Damage/scratches → Replace.
• Bearings "5"
Damage/pitting → Replace.
EAS23380

INSTALLING THE SWINGARM

1. Lubricate:
• Spacer
• Dust covers
• Pivot shaft
• Oil seals
• Collar
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Bearings "1", "2"
(to the swingarm)
• Oil seals "3"
New
(to the swingarm)
Installed depth of bearing "a"
0–1.0 mm (0–0.04 in)
Installed depth of bearing "b"
4.0 mm (0.16 in)
TIP
When installing the oil seals to the swingarm,
face the character stamp of the oil seals out-
side.
A. Left side
B. Right side
3. Install:
• Swingarm
• Pivot shaft
Pivot shaft nut
105 Nm (10.5 m·kgf, 76 ft·lbf)
4. Install:
• Drive chain
Refer to "INSTALLING THE DRIVE
CHAIN" on page 4-71.
• Rear shock absorber assembly
• Connecting arm
• Relay arms
• Rear wheel
Refer to "REAR SHOCK ABSORBER
ASSEMBLY" on page 4-62 and "REAR
WHEEL" on page 4-11.
5. Adjust:
• Drive chain slack
Refer to "ADJUSTING THE DRIVE
CHAIN SLACK" on page 3-18.
Drive chain slack
20.0–30.0 mm (0.79–1.18 in)
4-68
SWINGARM