Yamaha 2011 FZ8NA(C) Service Manual page 73

1. Clutch cable
2. Left handlebar switch lead
3. Main switch lead
4. Horn lead
5. Lower headlight stay
6. Throttle cable (return side)
7. Throttle cable (pull side)
8. Brake hose
9. Wire harness
10.Right handlebar switch lead
11.Throttle cables
A. Clamp the white tape mark of main switch
lead, and branches of left handlebar switch
lead, then insert the clamp into the upper
headlight stay. Face the end of the clamp
to the rear of the vehicle.
B. Route the horn lead further inward of the
vehicle than the center of the front fork.
The headlight side cover and front fork
must not be pinched.
C. The horn lead and lower bracket must not
interfere with each other.
D. Clamp the horn lead to the Lower headlight
stay and face the head of the clamp to out-
side of the vehicle and the end of the
clamp to the rear of the vehicle. Cut off the
excess end of the clamp, leaving 2–4 mm
(0.08–0.16 in).
E. Insert the bullet terminal of the horn lead in
the direction shown in the illustration.
F. The horn lead should not protrude out.
G. Clamp the wire harness at the branch and
insert it into the upper headlight stay. Face
the end of the clamp to the rear of the vehi-
cle.
H. Connect the meter coupler to the meter.
I. To the headlight lead coupler
2-42
CABLE ROUTING