Yamaha 2011 FZ8NA(C) Service Manual page 402

Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Item/components and
probable cause
2 Connection of wire harness
ECU coupler
Check the connection of the
coupler is secure.
Remove the coupler and
check each pin (for bending,
wear, or locking).
3 Continuity of wire harness
4 Installation status of atmo-
spheric pressure sensor
Check the mounting section
for a loose or pinched mount-
ing.
23
Atmospheric pressure sensor: open or short circuit detected. (no
normal signals are received from the atmospheric pressure sensor.)
Able to start engine
Able to drive vehicle
d:02
Displays the atmospheric pressure.
Compare the actually measured atmospheric pressure with the
meter display value.
Check or maintenance job
Poor connection → Connect it
securely, or replace the wire
harness.
Open or short circuit → Con-
nect it securely, or replace the
wire harness.
Black/blue–Black/blue
Pink–Pink
Blue–Blue
Make sure that the mounting
position is correct.
8-53
FUEL INJECTION SYSTEM
Sensor inspection proce-
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
Place the main switch to the
ON position, and check the
fault code indication.
No fault code indicated. →
Recovered.
Fault code indicated. →
Check the next step.
dure