Error Messages - Microlife WatchBP Office Targe Instruction Manual

Error messages

If an error occurs during measurement, the
measurement is interrupted and an error
message «Err» is displayed.
•
Please contact your local
Microlife service center if
the error persists.
•
If you think the results
are unusual, please read
through the information
in this instruction manual
carefully.
Error Description
«Err 1» Signal too
weak
«Err 2» Error signal
Potential cause and
remedy
The pulse signals on
the cuff are too weak.
Re-position the cuff and
repeat the measurement.
During the
measurement, error
signals were detected
by the cuff, caused for
instance by movement or
muscle tension. Repeat
the measurement,
keeping your arm still.
16
EN