Canon MultiPASS L90 User Manual page 189

Canon multipass l90 laser multifunction system
Hide thumbs Also See for MultiPASS L90:
Table of Contents

Advertisement

Message
NO RX PAPER
NO TEL #
NOT AVAILABLE NOW
OUTPUT TRAY FULL
PAPER IN MANUAL TRAY
PLEASE WAIT
REC. PAPER JAM
RECEIVED IN MEMORY
REPLACE CARTRIDGE
START AGAIN
SUPPLY REC. PAPER
Chapter 10
Error#
Meaning
#012
The receiving fax machine is out
of paper, or its memory is full.
#022
The button you pressed has no
number registered for one-touch
speed dialling, coded speed
dialling, or group dialling.
#025
In manual sending (using OFF
HOOK) you tried to use a one-
touch speed dial button or a coded
speed dial code that has a group
registered.
The face-down slot is full with
printed pages.
There is a print media in the
manual feed tray.
The unit is warming up.
The unit has a paper jam.
The unit received a fax in memory
because the paper or toner ran
out.
The toner cartridge is out of toner.
An error occurred on the phone
line or in the system.
#080
The other party may not have set
the subaddress.
#081
The other party may not have set
the password.
#102
The subaddress and/or password
does not match the settings on the
other party's fax unit.
#009
The unit is out of paper.
When manually printing or copying
several sheets, the next sheet was
not inserted into the manual feed
tray within 30 seconds.
Solutions
Call the other party and ask them to put
paper in their machine, or to clear their
fax machine's memory.
Print a list of registered numbers and
make any corrections needed, then try
again.
In manual sending you can not send a
document to multiple destinations. Send
the document to each location one at a
time.
Remove the pages from the face-down
slot.
Press
(START/COPY) to feed the
print media into the unit. (Qp.7-13)
If you are receiving a fax, remove the
paper or envelope from the manual feed
tray.
Wait until you see the standby mode
message, then begin.
Clear the paper jam. (Qp. 10-3)
Change the cartridge or add recording
paper, then print the fax from memory.
Replace the toner cartridge. (Qp. 2-20)
Start the procedure again from the
beginning.
Call the other party and check to see if
the subaddress has been set.
Call the other party and check to see if
the password has been set.
Call the other party and check to see if
the subaddress and the password are the
same as those of the other party.
Add more paper to the paper cassette.
Make sure the stack is below the limit
mark (
). (Qp. 2-25)
Start again from the beginning.
Frequently Asked Questions
10-17

Advertisement

Table of Contents
loading

Table of Contents