Yamaha XN125 2000 Service Manual page 200

ZAUM0051
HANDLEBAR
NOTE:
Align the projection on the left handlebar switch
with the hole in the handlebar.
6. Install:
• brake lever holder
NOTE:
Align the mating surfaces of the brake lever
holder with the punch mark a in the handlebar.
7. Install:
• throttle cable
• throttle grip
NOTE:
Lubricate the inside of the throttle grip with a thin
coat of lithium soap base grease and install it
onto the handlebar.
8. Install:
• right handlebar switch
WARNING
Make sure the throttle grip operates
smoothly.
NOTE:
• Align the projection on the right handlebar
switch with the hole a in the handlebar.
• There should be 2.5 mm of clearance between
the throttle grip and the right grip end .
9. Adjust:
• throttle cable free play
Refer to "ADJUSTING THE THROTTLE CA-
BLE FREE PLAY" in chapter 3.
Throttle cable free play
(at the flange of the throttle grip)
1.5 ~ 3.0 mm
7-33
CHAS