Assembling The Starter Motor - Yamaha XN125 2000 Service Manual

a
a
STARTER MOTOR
5. Measure:
• brush length a .
6. Measure:
• brush spring force
7. Check:
• gear teeth
8. Check:
• bearing
• oil seal
EAS00772

ASSEMBLING THE STARTER MOTOR

1. Install:
• Washer
• Brush
• Brush seat
NOTE:
Align the tab on the brush seat with the slot in the
starter motor rear cover.
2. Install:
• Armature assembly
• Stator assembly
• starter motor front cover
• starter motor rear cover
b
NOTE:
Align the match marks a on the starter motor
yoke with the match marks b on the front and
starter motor rear covers.
8-17
Out of specification → Replace the brushes
as a set.
Brush length
10 mm
<Limit>: 3.5 mm
Out of specification → Replace the brush
springs as a set.
Brush spring force
5.6 ~ 8.3 N
Damage/wear → Replace the gear.
Damage/wear → Replace the defective part(-s).
ELEC