Installing The Front Fork Legs - Yamaha XN125 2000 Service Manual

FRONT FORK
NOTE:
Be sure to bleed the front fork leg of any residual
air.
13. Measure:
• front fork leg oil level a
Out of specification → Correct.
Front fork leg oil level (from the top
of the inner tube, with the inner
tube fully compressed, and without
the spring)
80 mm
14. Install:
• spring
NOTE:
Install the spring with its denser of pitch to upper
side.
• O-ring
EAS00663

INSTALLING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Install:
• front fork leg
• cap bolt
• under bracket
• bracket bolt
NOTE:
Pull up the inner tube until it stops, then install
the cap bolt.
2. Tighten:
• cap bolt
• lower bracket pinch bolt
7-30
CHAS
45 Nm (4.5m•kg)
33 Nm (3.3m•kg)