Cs-Seat - Permobil C300 Service Manual

CS-seat

Removal
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not
work normally because the batteries are
discharged or the actuator is defective, the
seat can be
See page 22.
2. Switch off the main power switch on the
control panel.
3. If needed, remove the control panel, see
below.
4. Remove the four screws from under beneath,
see figure.
5. Remove the seat.
NOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
6. If needed, remove the leg rest unit, it is fitted
with four screws with washers and nuts,
see fig.
Fitting
Fit the seat in the reverse order.
NOTE
Always use the center holes on the leg rest unit when fitting it on
the Seat elevator/Fixed seat post.
NOTE
Always use the front holes on the seat when fitting it on the leg
rest unit.
Removing the Control Panel
1. Cut the wiring bundle tie holding the cabling
together. Take note of the location of the wiring
bundle tie for purposes of later remounting.
2. Loosen the knob (1), see figure.
3. Pull the Control Panel forwards.
Fitting
Fit the Control Panel in the reverse order.
Removing the Control Panel bracket
1. Remove the three screws (2) holding the
bracket.
Fitting
Fit the Control Panel bracket in the reverse order.
raised/lowered manually.
The seat is fitted with four screws.
The Legrest unit is fitted with four
screws with washers and nuts.
Use the center holes on the leg rest unit when
fitting it on the seat lift/fixed seat post.
Use the front holes on the seat when
fitting it on the leg rest unit.
1
The Control Panel bracket.
27
CS-seat
2