Corpus-Seat - Permobil C300 Service Manual

Corpus-seat

Corpus-seat
Removal
1. Raise the seat; seat elevator to the highest
position; fixed seat tube to the service position.
See page 24. If the seat elevator does not
work normally because the batteries are
discharged or the actuator is defective, the
seat can be raised/lowered
See page 22.
2. Switch off the main power switch on the
control panel.
3. Remove the cushion from the seat.
4. Remove the seat plate. It's mounted using two
screws.
Removing seat on chassis without seat tilt
5. If needed, remove the control panel, see
page 30.
6. Remove the four screws holding the seat,
see figure.
7. Remove the seat.
NOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
Removing seat and seat
tilt on chassis with seat tilt
5. Switch on the main power switch on the control
panel. Tilt the seat approx. 20°. Switch off the
main power switch on the control panel.
6. If needed, remove the control panel, see
page 30.
7. Remove the four screws holding the seat,
see figure.
8. Remove the seat.
NOTE
Because the seat is heavy, it should be lifted by two persons. Be
careful with the cabling.
Fitting
Fit the seat in the reverse order.
manually.
The seat plate is fitted with two screws.
On chassis without seat tilt, the seat is fitted with
On chassis with seat tilt, the seat is fitted
28
two screws on each side.
with four screws.