Machine Safety Regulations - SunStar SPS/A-Pattern Series User Manual

MACHINE SAFETY REGULATIONS

Safety instruction on this manual are defined as Danger, Warning and Notice.
If you do not keep the instructions, physical injury on the human body and machine damage might be occurred.
: This indication should be observed definitely. If not, danger could be happen during the installation,
Danger
conveyance and maintenance of machines.
Warning : When you keep this indication, injury from the machine can be prevented.
: When you keep this indication, error on the machine can be prevented.
Notice
1-1) Machine
Transportation
1-2) Machine Installation
1-3) Machine Repair
6
Those in charge of transporting the machine should know the safety regulations very well.
The following indications should be followed when the machine is being transported.
More than 2 people must transport the machine.
To prevent accidents from occurring during transportation, wipe off the oil on the machine
well.
The machine may not work well or breakdown if installed in certain places, Install the machine
where the following qualifications agree.
Remove the package and wrappings starting from the top. Take special notice on the nails
on the wooden boxes.
Dust and moisture stains and rusts the machine. Install an airconditioner and clean the
machine regularly.
Keep the machine out of the sun.
Leave sufficient space of more than 50cm behind, and on the right and left side of the
machine for repairing.
EXPLOSION HAZARDS
Do not operate in explosive atmospheres. To avoid explosion, do not operate this machine
in an explosive atmosphere including a place where large quantities of aerosol spray
product are being used or where oxygen is being administered unless it has been
specifically certified for such operation.
The machine were not provided with a local lighting due to the feature of machine.
Therefore the illumination of the working area must be fulfilled by end user.
[Refer] Details for machine installment are described in Mechanical Structure Manual
4. Machine Installment.
When the machine needs to be repaired, only the assigned troubleshooting engineer educated at
the company should take charge.
Before cleaning or repairing the machine, close down the motive power and wait 5
minutes till the machine is completely out of power.
Not any of the machine specifications or parts should be changed without consulting the
company. Such changes may make the operation dangerous.
Spare parts produced by the company should only be used for replacements.
Put all the safety covers back on after the machine has been repaired.