Special Functions - SunStar SPS/A-Pattern Series User Manual

SPECIAL FUNCTIONS

1) Auto Call Function
The function that a user can automatically call designs through the external input port can be added. In addition, the
user can control the signals for Clamp, Emergency Switch, Enter Key, Sewing Start Pedal, and so on via the external
input port.
This function is useful when the user desires it.
Therefore, since the specification is special, make sure to apply the function when there is a request only. When using it,
call for the assistance from Technical Assistant.
Take extra care to prevent the regular user from using this function.
This function is applicable to the machine types as below.
Applicable Model
SPS/A/B - 1306, 1310, 1507, 1811, 2211, 2516,
SPS/A - 3020, 5030, 5034,
SPS/C - 5050, 8050
Requirements for Application
In case of SPS/A/B-Series, the existing I/O board cannot be used since the number of external input ports is small. In this
case, the I/O board of SPS/C-Series should be used.
In case of SPS/C-series, there is no need to change.
As such, when the special specifications are requested for SPS A/B series, make sure to replace its I/O board with the I/O
Board of C-Series before release.
In some cases where the installation of SPS/C-Series' Operation Box is requested, the replacement can be conducted before
release (To use the OP, lift Dip Switch 6 on the I/O board.)
Cautions for Application
The specification of the main shaft motor is FORTUNA-IV's main shaft motor. Previously, SANYO's main shaft motor was
used. Therefore, the currently applied pattern's version is the integrated version which is applicable to both FORTUNA-IV
and SANYO.
In order to use the two motors, the main shaft board's specification was changed to the integrated version.
If the user applies the Auto Call function in the prevision version, not the integrated version, he/she should replace the C-
Series I/O board and ROM BIOS (not the integrated specifications).
When the integrated specification is applied, C-Series I/O Board and ROM BIOS(integrated version) need to be replaced.
In the event that the integrated specification version is applied when the Sanyo motor is used, replace the C-Series I/O
Board, the main shaft board of the integrated board (apply the Jumper setting in line with the motor), and ROM BIOS of the
integrated version.
Version Application
When using this function, the previous version ROM BIOS should be fully replaced.
(notified ROM BIOS versions by model)
To check out the version, see the version mark on ROM BIOS.
183