Glossary; Additional Memory - Kyocera 1650 Advanced Operation Manual

Appendix

Glossary

Additional memory

An additional memory (optional) is used for increasing the memory capacity of this machine. In this
machine, a memory can be added for the copier functions and the printer functions respectively.
(For copier: 16 MB, 32 MB, 64 MB, and 128 MB/for printer: 32 MB, 64 MB, 128 MB, and 256 MB)
For DIMM that can be used in this machine, contact your dealer.
AppleTalk
This is a networking function that is built-in to Apple Computer Inc's Mac OS. It is also the general
term given to the protocol that runs on AppleTalk networks. AppleTalk offers file sharing and printer
sharing and it also enables you to start application software installed on another computer on the
same AppleTalk network.
APS (Auto Paper Selection)
This mode will automatically select copy paper of the same size as the original.
Default Gateway
This is the address of a device, such as a computer or router, that serves as the entrance/exit
(gateway) for accessing computers outside of your network. When no specific gateway is
designated for a destination IP address, data is sent to the host that is designated as the Default
Gateway.
DHCP (Dynamic Host Configuration Protocol)
This is a protocol that automatically resolves the IP address, subnet mask, and gateway address on
a TCP/IP network. Use of DHCP minimizes the load of network administration, especially on
network environments with a large number of client computers because it is not specifically
necessary to assign a separate IP address to each client, including printers.
dpi (dots per inch)
This indicates the number of dots printed per inch (25.4 mm) as a unit for expressing resolution.
EcoPrint
This is a printing mode that reduces toner consumption. Pages printed in the EcoPrint mode are
lighter than pages printed in the normal mode.
Emulation
This is a function that interprets the page description language of other printers and executes the
commands. The printer emulates operation of the following printers: PCL6, KPDL, KC-GL, Line
Printer, IBM Proprinter, DIABLO 630, and EPSON LQ-850.
Form feed timeout
While data is being sent to a printer, some pauses may occur. At this time, the printer waits for the
next data without making a page break. Form feed timeout is a function to wait only a preset amount
of time before it executes an automatic page break. After the waiting period begins, once the
designated amount of time is exceeded, the printer will automatically process the currently received
data and print it out. If the machine has received no print data for the last page, the printer ends
processing of that job without outputting paper.
IEEE1284
This is a standard used for connecting a printer to a computer, and was established by the IEEE
(Institute of Electrical and Electronic Engineers) in 1994.
IP Access control
This is a function to prohibit access to this machine from a host with an IP address that is not
approved.
Appendix-16