Set Supervisor / User Password - Acorp 7KT266A User Manual

Chapter 2 Chapter 2
Chapter 2 Chapter 2 Chapter 2

2.12 Set Supervisor / User Password

¡·Figure 12. Set Supervisor / User Password
¡· ¡· ¡· ¡·
CMOS Setup Utility-Copyright (C) 1984-2001 Award Software
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management Setup
Enter Password:
PNP/PCI Configuration
PC Health Status
Esc : Quit
F10 : Save & Exit Setup
Time , Date , Hard Disk Type ...
When you select this function, the following message will
appear at the center of the screen to assist you in creating a
password.
Type a password, up to eight characters, and press <Enter>.
The password you type now will clear any previously entered
password from CMOS memory. You will be asked to
confirm the password. Type the password again and press
<Enter>. You may also press <ESC> to abort the selection
and not enter a password. To disable the password, just press
<Enter> when you are prompted to enter a password. A
message will confirm that you wish to disable the password.
Once the password is disabled, the system will boot and you
can enter setup freely.
Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
←→↑↓: Select Item
Enter Password
2-38 2-38 2-38
2-38 2-38
BIOS Setup BIOS Setup
BIOS Setup BIOS Setup BIOS Setup