Stage 4 - Installing The Tail - Hangar 9 VRTF Easy 2 Instruction Manual

Stage 4 — Installing the Tail
Parts Needed
• Fuselage with radio gear installed from Stage 3
• Horizontal tail section
• Vertical tail section
• 4-40 x 3/8 " Machine screws (2)
Step 19. Attach the vertical tail to the horizontal tail. The
threaded rods protruding from the vertical tail pass through the
front two holes in the horizontal tail.
Note: The colored trim on the horizontal tail should face up.
Screw on the two wing nuts provided to secure the vertical tail to
the horizontal tail. Tighten just until they're snug.
16
Horizontal Wing Washers
Tail Nuts
• Washers (2)
• Wing Nuts (2)
• Thread locker (tube)
4-40 x 3/8´´ Thread
Machine Screws Locker
Important Safety Note: The wing nuts must be tightened
to a 45 degree angle to the horizontal tail (either
direction), which prevents them from loosening when
installed in the fuselage.
Vertical
Tail