Installing The Propeller; Installing The Antenna - Hangar 9 VRTF Easy 2 Instruction Manual

Installing the Propeller

You will need to purchase the appropriate propeller for your
particular engine. If you have a .40 size engine, a 10 x 6
propeller will work. For .46 size engines, an 11 x 6 is the correct
propeller.
Unscrew the prop nut from the engine and install the spinner
back plate, then the propeller, then the prop washer. Securely
tighten the prop nut using a 4-way or crescent wrench. Now
install the spinner using the two Phillips head screws provided.

Installing the Antenna

Remove the wing and unhook the aileron connector. Uncoil the
receiver. Locate the antenna tube included in the Easy 2. Pull
about 5" of antenna wire past the end of the antenna and secure
by wrapping a rubber band around the tube to hold the antenna
in place. Insert the antenna tube through the back of the
fuselage. Tuck the front of the tube just behind the servos in the
fuselage.
Note: You can thread the antenna through the tube, but this
time consuming task is unnecessary. Rubber banding
the antenna to the tube is just as effective.
23