Hangar 9 VRTF Easy 2 Instruction Manual page 20

Stage 5 — Installing the Landing Gear
Step 24. Place the steering arm on the Z-bend (using the
innermost hole) with the screw pointing toward the front. Now
pass the wire nose wheel assembly through the steering arm,
then through the spring, then through the black molded nose
wheel bearing on the front of the fuselage, then through the
collar, then through the engine mount. See the photo for correct
placement. Tighten the screw in the collar, leaving the spring
fully extended.
Step 25. Turn the plane over and again center the rudder servo
(see Step 14). Adjust the steering pushrod so the nose wheel
steering arm is parallel with the front of the firewall. To adjust,
lengthen or shorten the nose wheel pushrod by screwing in or
out on the nose wheel pushrod clevis.
20
Step 26. With the rudder servo's control arm centered, adjust
the nose wheel so that it's straight with the fuselage. Sight down
the fuselage to make sure it's straight. Tighten the steering arm
screw securely.
Step 27. To hold the wing in position, we will install two dowel
rods in the fuselage. Slide the dowel rods through the holes in
the top of the fuselage (one in front and back). Continue pressing
into place until an even amount comes out of either side.
Note: This will be a tight fit.
CONTINUED